Whirlpool

(Depending on accommodation type)

To use the whirlpool function, the bath must at least be half filled with water. When the display lights up blue, the whirlpool is ready to use. If the display only flashes blue, the water level is still too low.

• To turn on the whirlpool, press the on/off button.
• Use the + and - buttons change the intensity of the bubbles.
• ​By pressing the light button, the light in your bath turns on and continues to change colour to create a relaxing atmosphere.

PLEASE NOTE: After using the whirlpool function, the cleaning function will run for about 30 minutes. This may cause some noise, but shuts off automatically when finished. Please do not hang (wet) towels over the bathtub rim. The sensor remains activated and therefore the cleaning program does not start until the towels are dried or removed.